Benq MS517 用户手册

下载
页码 74
Troubleshooting 67
Troubleshooting
The projector does not turn on.
No picture
Blurred image
Remote control does not work
The password is incorrect
Cause
Remedy
There is no power from the power cable.
Plug the power cord into the AC inlet on the 
projector, and plug the power cord into the 
power outlet. If the power outlet has a switch, 
make sure that it is switched on.
Attempting to turn the projector on again 
during the cooling process.
Wait until the cooling down process has 
completed.
Cause
Remedy
The video source is not turned on or 
connected correctly.
Turn the video source on and check that the signal 
cable is connected correctly.
The projector is not correctly connected 
to the input signal device.
Check the connection.
The input signal has not been correctly 
selected.
Select the correct input signal with the SOURCE 
key on the projector or remote control.
The lens cover is still closed.
Open the lens cover.
Cause
Remedy
The projection lens is not correctly 
focused.
Adjust the focus of the lens using the focus ring.
The projector and the screen are not 
aligned properly.
Adjust the projection angle and direction as well 
as the height of the unit if necessary.
The lens cover is still closed.
Open the lens cover.
Cause
Remedy
The battery is out of power.
Replace the battery with new one.
There is an obstacle between the remote 
control and the projector.
Remove the obstacle.
You are too far away from the projector.
Stand within 8 meters (26 feet) of the projector.
Cause
Remedy
You do not remember the password.
 for details.