Advantek Networks AWN-AP-54MR 用户手册
6
HARDWARE CONNECTION
Note: Before you starting hardware connection, you are advised to find an
appropriate location to place the Access Point. Usually, the best place for the
Access Point is at the center of your wireless network, with line of straight to all
your wireless stations. Also, remember to adjust the antenna; usually the
higher the antenna is placed, the better will be the performance.
appropriate location to place the Access Point. Usually, the best place for the
Access Point is at the center of your wireless network, with line of straight to all
your wireless stations. Also, remember to adjust the antenna; usually the
higher the antenna is placed, the better will be the performance.
1. Connect to your local area network: connect a Ethernet cable to one of
the Ethernet port (LAN1 or LAN2) of this Wireless Access Point, and the
other end to a hub, switch, router, or another wireless access point.
other end to a hub, switch, router, or another wireless access point.
2. Power on the device: connect the included AC power adapter to the
Wireless Access Point’s power port and the other end to a wall outlet.
Check the LEDs:
The Power and LAN # LEDs should be ON. LAN# LED will even blink if there is
traffic.
traffic.
The Link/Act LED will be on in static when associated with a station and blink
whenever this AP receives data packets in the air.
whenever this AP receives data packets in the air.
If the Status LED glows after self-test , it means this Wireless Access Point
fails on self test. Please ask your dealer for technical support.
fails on self test. Please ask your dealer for technical support.
3. Configure your PC: Make sure your local PC(s) has wireless network
adapter installed.