Allied Telesis AT-9900 用户手册
74
Internet Protocol (IP) Enhancements
Release Note
Software Version 2.8.1
C613-10477-00 REV B
C613-10477-00 REV B
destination is unknown. You may need to increase the timeout period if you
are communicating with devices that are slow to respond. The default is 1
second.
are communicating with devices that are slow to respond. The default is 1
second.
Example
To set the router or switch to wait 2 seconds after you ping a device before
declaring that the device is unreachable, use the command:
declaring that the device is unreachable, use the command:
set ip arpw=2
set ip filter
Syntax
SET IP FILter=0..999
{ACtion={INCLude|EXCLude}|POLIcy=0..15|PRIOrity=P0..P7}
SOurce=ipadd [SMask=ipadd] [SPort={port-name|port-id}]
[DEStination=ipadd [DMask=ipadd]]
[DPort={port-name|port-id}]
[ICMPCode={icmp-code-name|icmp-code-id}]
[ICmptype={icmp-type-name|icmp-type-id}]
[LOG={4..1600|Dump|Header|None}]
[OPtions={False|OFF|ON|NO|True|YES}]
[PROTocol={protocol|Any|Icmp|Ospf|Tcp|Udp}]
[SEssion={Any|Established|Start}] [SIze=size]
[ENTry=1..255]
Description
This command changes a pattern in an IP traffic filter, policy filter, priority
filter or routing filter. You can now specify a greater range of filter numbers in
the set ip filter command. The new range is between 0 and 999.
filter or routing filter. You can now specify a greater range of filter numbers in
the set ip filter command. The new range is between 0 and 999.
set ip route preference
Syntax
SET IP ROUte PREFerence={DEFault|1..65535}
PROTocol={BGP-ext|BGP-int|OSPF-EXT1|OSPF-EXT2|
OSPF-INTEr|OSPF-INTRa|OSPF-Other|RIP|ALL}
The protocol parameter specifies which protocol’s routing table is updated
with the new preference value. If all is specified, all protocol routing tables are
updated with the new preference value.
with the new preference value. If all is specified, all protocol routing tables are
updated with the new preference value.