RAD Data comm Modular Access Device with Integrated Router 用户手册

FCD-IPM Installation and Operation Manual 

Chapter 4  Configuration 

 

Quick Setup Menu 

4-11 

FCD-IPM is available with ISDN “S” and “U” options. 

   

Assigns the protocol provided by the ISDN service in your 
area. Some additional parameters may be requested 

depending on the selected protocol. 

 

56, 64, 112, 128 kbps  Assigns a bandwidth. The bandwidth is the rate at which data 

passes through the link. The greater the bandwidth, the more 

information can be sent through the link. FCD-IPM allows 

you to work with a bandwidth of 56, 64, 112, or 128 kbps. 
Selection of 112 or 128 kbps for protocols other than IDSL 

means MLPPP will be invoked. 

 

Specifies the type of connection used to connect to the 

Internet or Intranet.  
If the link is to be used only for receiving incoming 
connections 
If the link is to be used for both incoming and out going 

connections (not simultaneously) 
If the link is to be used for outgoing connections only. 

 

Defines the phone number used to connect to the Internet or 
Intranet. To edit the phone number, erase the number with 

the Backspace key and enter the new number. This 

parameter appears only when the connection type is 

 or Answer&Originate. 

 

Determines when the link between the local LAN and the 

Internet should be activated. Selecting any frame for 
forwarding, activates the link only when there is traffic to be 

sent on the link. Selecting Always keeps the link active, 

independent of traffic. The Connection parameter is 
important in reducing operating costs. 

 

 

You need to set the DCLI number, to allow connection to the Frame Relay 
network without setting Frame Relay parameters. 

Select this parameter to set the DLCI number.