Adtran L128 用户手册
Chapter 1: Understanding ISDN and the Express L128/L128T
16
Express L128/L128T User Manual
61202.070L1-1
Network Address Translation Mode
NAT is a special mode of operation in which the Express L128/L128T obtains
a dynamically assigned IP address from the peer router (typically an Internet
Service Provider). This allows a network of computers to benefit from Ether-
net to ISDN speeds while still appearing to the Internet Service Provider (or
central site router) as a single IP address, which is typical of PC based serial
dial-up solutions.
a dynamically assigned IP address from the peer router (typically an Internet
Service Provider). This allows a network of computers to benefit from Ether-
net to ISDN speeds while still appearing to the Internet Service Provider (or
central site router) as a single IP address, which is typical of PC based serial
dial-up solutions.
A call is initiated to the ISP using the Dial menu or demand for a Connection
List profile that has the IP parameter NAT set to Yes. The network computer’s
IP stack may use DHCP to request an IP address, default gateway address, and
domain name server addresses from the Express L128/L128T.
List profile that has the IP parameter NAT set to Yes. The network computer’s
IP stack may use DHCP to request an IP address, default gateway address, and
domain name server addresses from the Express L128/L128T.
Front Panel
Figure 1-6 on page 17 shows the front panel of the Express L128/L128T. The
indicators are divided into LAN functions, WAN functions, and Test func-
tions.
indicators are divided into LAN functions, WAN functions, and Test func-
tions.
LAN Indicators
TX/RX
Flashes green when transmitting data onto the 10BaseT
connector.
Flashes yellow when receiving data from the 10BaseT
connector.
LI
Link integrity. Illuminates when there is a good connection
between the Express L128/L128T and the Hub/NIC card.