Motorola Canopy Backhaul Module 用户手册
Backhaul User Manual Issue 3
Page 24 of 53
module so that it can register with a backhaul timing master module. The color codes must
match.
match.
The operator can prevent unauthorized users from connectig to the backhaul module’s web based
interface by assigning a password. There is no default password and password protection is turn
off is turn off from the factory.
interface by assigning a password. There is no default password and password protection is turn
off is turn off from the factory.
Passwords can be from 1 to 16 characters. Any combination of characters is allowed, except for
these special characters: “ , . ‘ { } / \ ; : [ ] ( ) ` ~
these special characters: “ , . ‘ { } / \ ; : [ ] ( ) ` ~
NOTE: If the operator forgets either the password or the IP address for the module, a Canopy
default plug can be used to regain access. See
default plug can be used to regain access. See
Configuration
for information on the default plug.
There are two types of passwords that can be configured: display-only or full-access. The display-
only password allows the operator to view the module’s current status. The full-access password
allows the operator to view the module’s current status and change its configuration. By viewing
the red lettering to the right of the entry fields, the operator can discern that a password is set.
only password allows the operator to view the module’s current status. The full-access password
allows the operator to view the module’s current status and change its configuration. By viewing
the red lettering to the right of the entry fields, the operator can discern that a password is set.
The operator can enter in information about the Site Name, Location, and Contact. This is optional.
See the
Access Point Cluster and Cluster Management Module
user manual for details
on configuration and installation of a cluster management module.
Installation of the equipment
When power is applied to a Canopy module or the unit reset via the web-based interface, the
module will take approximately 25 seconds to boot up. During this boot up time, power on self-
tests and other diagnostics are being performed.
module will take approximately 25 seconds to boot up. During this boot up time, power on self-
tests and other diagnostics are being performed.
The following steps are needed to install the Canopy equipment:
• Remove the base cover from all Canopy backhaul timing master modules to be installed.
• Remove the GPS sync cable knockout from the base cover with needle-nose pliers.
• Mount the backhaul modules:
• Remove the GPS sync cable knockout from the base cover with needle-nose pliers.
• Mount the backhaul modules:
o
The modules can be mounted in a variety of locations, choose the best location
for your particular application. Mounting can be done by utilizing stainless steel
hose clamps or another equivalent fastener.
for your particular application. Mounting can be done by utilizing stainless steel
hose clamps or another equivalent fastener.
• Route the Ethernet cable from the backhaul module to the cluster management module.
o
The Ethernet cables use RJ-45 connectors (standard Ethernet) that connect to
matching ports within the cluster management module.
matching ports within the cluster management module.
o
A total of 8 ports are available on the cluster management module, to
accommodate a combination of access point modules and backhaul timing master
modules.
accommodate a combination of access point modules and backhaul timing master
modules.
• Route the GPS sync (serial) cable from the backhaul timing master module to the cluster
management module.
o
The GPS sync cables use 6 conductor RJ-11 connectors that connect to matching
ports within the cluster management module.
ports within the cluster management module.