AB Soft MS6 SERIES 用户手册
Opal Pro to Mod TCP
Page 6
Opal Pro to Mod TCP
Introduction
The Opal Pro can be monitored and controlled over an Ethernet
communication network using the AB Ethernet IP protocol. The Opal Pro
connects to the Ethernet network through and optional Ethernet card that
is mounted on the main Opal Pro control card (CA530). Access is gained
to the Ethernet card via the communication opening on the right side of
the Opal Pro. The Opal Pro is a AB Ethernet IP slave and is mapped as
I/O through an Ethernet bridge
communication network using the AB Ethernet IP protocol. The Opal Pro
connects to the Ethernet network through and optional Ethernet card that
is mounted on the main Opal Pro control card (CA530). Access is gained
to the Ethernet card via the communication opening on the right side of
the Opal Pro. The Opal Pro is a AB Ethernet IP slave and is mapped as
I/O through an Ethernet bridge
Hardware
Connection is made via a 10Mbaud Ethernet port which utilizes a RJ45
connector. Connection should be made using CAT 5 cable.
connector. Connection should be made using CAT 5 cable.
Jumper Settings
Jumper
Setting
Description
J3
Not installed
Boot Block write enable
J4
Installed on
pins 1 and 2
pins 1 and 2
Disable test mode