Renesas M16C PC4701 用户手册
7 Windows/Dialogs
7.7 H/W Break Point Setting Window
The H/W Breakpoint Setting window is used to set hardware breakpoints for the Emulators.
•
The events listed below can be specified as break events. If the contents of events are altered,
they are marked by an asterisk (*) on the title bar. The asterisks (*) are not displayed after
setting up the emulator.
-
they are marked by an asterisk (*) on the title bar. The asterisks (*) are not displayed after
setting up the emulator.
-
The debugger for M32C
Memory Access, Bit Access, External Trigger
(* Can be substituted by memory access. (Access type = Read))
Memory Access, Bit Access, External Trigger
(* Can be substituted by memory access. (Access type = Read))
-
The debugger for M16C/R8C
Fetch, Memory Access, Bit Access, Interrupt, External Trigger
Fetch, Memory Access, Bit Access, Interrupt, External Trigger
-
The debugger for 740
Fetch, Memory Access, Bit Access, Interrupt, External Trigger
Fetch, Memory Access, Bit Access, Interrupt, External Trigger
•
Events at up to six points can be used.
•
These events can be combined in one of the following ways:
-
-
Break when all of the valid events are established (AND condition)
-
Break when all of the valid events are established at the same time (simultaneous AND
condition)
condition)
-
Break when one of the valid events is established (OR condition)
-
Break upon entering a break state during state transition (State Transition condition)
•
At the time the debugger starts up, the hardware breaks have no effect.
101