RAD Data comm IPmux-11 用户手册

Chapter 4  Configuration 

Installation and Operation Manual 

4-30 Additional 

Tasks 

IPmux-11 Ver. 2.00 

Monitoring>Status>Eth Physical layer 
 
    Channel                  >   (Network-Eth1) 
    Mode                     >   (Full Duplex) 
    Rate(Mbps)               >   (100) 
    Status                   >   (Connected) 
 
 
 
 
> 
 
 
F - forward 
ESC-prev.menu; !-main menu; &-exit                                   1 Mngr/s 

You can display information on the current bundle connection, its connectivity 
status, collected sequence errors, and statistics for underflows and overflows of the 
jitter buffer (see 

 for details on the bundle statistics).  

 

To display the bundle connection information: 
1.  From the Status menu, select Connection. 

The Connection screen is displayed (see 

). 

2. Select Bundle ID and enter the number of the bundle whose status you wish 

to display. 
The Bundle Status screen contains the following information: 

 

Connectivity Status: 

 

Disabled: No activity in the channel. The channel is disabled. 

 

OK: Both the remote and the local IPmux receive Ethernet frames, 
(however, there may be problems such as sequence errors, underflows, 
overflows, as explained below).  

 

Local Fail: The local IPmux-11 does not receive Ethernet frames. 

 

Remote Fail: The remote IPmux-11 does not receive Ethernet frames. 

 

Unavailable: The remote IPmux-11 does not reply to OAM messages 
(only applicable when OAM is enabled). 

 

Validation Fail: The remote IPmux-11 replies, but there is a 
configuration error (only applicable when OAM is enabled). 

 

Standby: Redundant bundle is OK and waiting for redundancy switching 
(only applicable when Redundancy is enabled). 

 

TDM Fail: There is LOS/LOF at the TDM side (only applicable when 
Redundancy is enabled).