Lantronix 1-T2 用户手册
Basic Configuration
Serial Port Configuration
4 - 5
¥
Autobaud
: The autobaud feature can be enabled or disabled (the
default). When enabled, the MSS will automatically attempt to
match its speed to that of the remote device upon connection.
match its speed to that of the remote device upon connection.
Ex:
CHANGE AUTOBAUD ENABLED
¥
Character Size
: The MSS can use 8 data bits (the default) or 7.
Ex:
CHANGE CHARSIZE 7
¥
Stop Bits
: The MSS can use 1 stop bit (the default) or 2.
Ex:
CHANGE STOPBITS 2
¥
Parity
: The MSS supports even and odd parity, as well as settings
of Mark, Space, and None (the default).
Ex:
CHANGE PARITY EVEN
¥
Flow Control
: Both RTS/CTS (hardware) and XON/XOFF
(software) ßow control methods can be used on the MSS. RTS/CTS
controls data ßow by sending serial port signals between two
connected devices. XON/XOFF, the default, sends particular
characters through the data stream instead. If no ßow control is
desired, specify ÒNone.Ó
controls data ßow by sending serial port signals between two
connected devices. XON/XOFF, the default, sends particular
characters through the data stream instead. If no ßow control is
desired, specify ÒNone.Ó
Ex:
CHANGE FLOW CONTROL CTSRTS
NOTE:
Applications that use the control characters will conflict with
XON/XOFF flow control, in which case RTS/CTS is
recommended.
XON/XOFF flow control, in which case RTS/CTS is
recommended.
¥
Modem Control
: When enabled, this feature allows the MSS to
check for signals coming from the modem (or other attached serial
device) to establish whether a valid connection exists. When
modem control is enabled, the port will be logged out whenever
DSR is de-asserted, and the MSS will de-assert DTR to end the
connection to the remote device. It is disabled by default.
device) to establish whether a valid connection exists. When
modem control is enabled, the port will be logged out whenever
DSR is de-asserted, and the MSS will de-assert DTR to end the
connection to the remote device. It is disabled by default.
Ex:
CHANGE MODEM CONTROL ENABLED
¥
Signal Checking
: When signal checking is enabled, the MSS will
check for the presence of a DSR signal before allowing an incoming
connection. Remote connections to the serial port will not be
permitted unless the DSR signal is asserted. It is disabled by
default.
connection. Remote connections to the serial port will not be
permitted unless the DSR signal is asserted. It is disabled by
default.
Ex:
CHANGE SIGNAL CHECK ENABLED