GE 1018959 用户手册
•
Connect the power to the box (left-most connector in the picture above). Make sure that the
SNMP/WEB Interface box is powered by the UPS output!
SNMP/WEB Interface box is powered by the UPS output!
•
The UPS / Fail LED will switch OFF once the connection to the UPS is established.
If the LED remains continuously on, check the UPS connection and related cabling.
If the LED remains continuously on, check the UPS connection and related cabling.
3.5 INTERFACES
UTP 10/100 – RJ45 port
Connection to an Ethernet 10/100 Mbits/s networks, using an UTP cable.
Connection to an Ethernet 10/100 Mbits/s networks, using an UTP cable.
RS-232 – DB9 port
Serial communication, connection to a local console.
Use a straigth (1:1) serial cable for connection to a PC.
Serial communication, connection to a local console.
Use a straigth (1:1) serial cable for connection to a PC.
1
2
3
4
5
6
2
3
4
5
6
1
2
3
4
5
6
2
3
4
5
6
2
3
3
5
4
1
6
7
8
9
7
8
9
TD
RD
2
3
3
5
4
1
6
7
8
9
7
8
9
TD
RD
Connector pin-out as follows:
Pin #
Pin #
Function
2
TD – Transmit Data
3
RD – Receive Data
5 GND
Contact interface – RJ11 port (1-ph plug-in version only)
Plug-in contact interface port.
Connector pin-out as follows:
Pin #
Plug-in contact interface port.
Connector pin-out as follows:
Pin #
Function
1
Mains failure
2
General alarm *
3
Battery low
4
On bypass
5
N.C.
6
GND
(*) Active if the output voltage of the UPS is no longer guaranteed due to other circumstances than
already indicated by pin 1-3-4.
CAUTION !
The DB9 and RJ11 port share the same GND signal.
Exercise caution when both interfaces are used at the
same time, particularly when connecting these interfaces
to non-floating ground systems.
same time, particularly when connecting these interfaces
to non-floating ground systems.
Modifications reserved
Page 18/24
ISG_CNT_SNM_BAS_CRD_1GB_V012.doc
Installation Guide SNMP/Web Adapter