Extron electronic 200 用户手册

 

3.   Install Any Necessary Split Grommets and 

Hole Plugs

Slip the appropriate split grommet over each 
cable with the flange of the grommet toward 
the connector that will be accessible inside 
the Cable Cubby. Snap the grommets into the 
channels.

If necessary, snap the included hole plugs into 
unused holes.

4.   Adjust the Cable Position

The Cable Cubby 200 has four cable stand-offs that 
set the height of the cables inside the enclosure.

Choose the row that best lifts the cable 
connectors off the cable pass-through AAP and 
still allows the lid to be closed.

Insert the stand-off into the Cable Cubby and 
align the ends with opposing horizontal slots in 
the side of the enclosure.

Loosely install the Phillips head screws and 
washers so the stand-offs remain attached, but 
can be easily adjusted within the slots.

Install a second stand-off next to the first  
stand-off, in accordance with steps 

4a, 4b, and 

4c.

Slide the stand-offs back and forth in the 
horizontal slots to position them so that the 
cables easily rise and lower but do not fall 
below the stand-offs.

Tighten the Phillips head screws of the  
stand-offs to lock them into position.

Repeat steps 

4a through 4f until all the cable 

connectors have been accompanied with  
stand-offs.

5.   Install Optional Passive AAPs

The pass-through AAPs can be replaced with 
Extron passive AAPs.

Unscrew the nuts on the underside of the shelf 
that fasten the set of pass-through AAPs to the 
enclosure.

Connect cables to the rear of the AAPs to be 
installed before attaching it to the enclosure.

Insert the screws of the AAPs through the holes 
in the shelf. Secure the AAPs to the shelf with 
the provided captive washers and #4-40 nuts.

Cable Stand-off

Ü

á