Cisco Systems 1105 用户手册
Chapter 6 Performing Administrative Tasks
Using Discovery and Managing Devices
6-12
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14947-01
Related Topic
Set Up Devices
You must set up devices so the WLSE can discover and manage them. This section
describes both required and optional setup tasks for:
describes both required and optional setup tasks for:
•
•
•
Set Up Access Points and Bridges
You can set up access points and bridges in two ways:
•
By using the WLSE’s automatic configuration option for first-time device
configuration (select Configuration > Auto Update). For more information,
see
configuration (select Configuration > Auto Update). For more information,
see
•
By opening a web browser session on each device and perform the tasks in
the following table. To use this method, you must first configure each access
point or bridge for web browsing.
the following table. To use this method, you must first configure each access
point or bridge for web browsing.
Table 6-4
Set Up Procedures for Access Points and Bridges
Tasks
Procedure
Notes
1. Enable Cisco
Discovery Protocol
(CDP).
Discovery Protocol
(CDP).
1.
In the Summary Status page, click
Setup. The Cisco Services Setup
page appears.
Setup. The Cisco Services Setup
page appears.
2.
Under Services: Cisco Services, click
Cisco Discovery Protocol. The CDP
Setup page appears.
Cisco Discovery Protocol. The CDP
Setup page appears.
3.
Select Enabled. Click Apply or OK.
CDP is required for the WLSE to
discover devices on the network.
discover devices on the network.