ZyXEL Communications n/a 用户手册

DSL & IAD CLI Reference Guide

Use these commands to configure bridge settings on your device.

The following table describes the values required for many bridge commands. Other values 
are discussed with the corresponding commands.

The following section lists the bridge commands..

Table 16   Bridge Command Input Values

This identifies a bridge route (1-4).

This identifies a bridge group number (1~31).

Table 17   Bridge Commands

bridge cnt clear <entry#>

Resets the packet statistics counter for the specified bridge.

bridge cnt disp <entry#>

Displays the packet statistics table for the specified bridge.

bridge stat active <on|off>

Enables or disables the bridge specified with the index command. More 
than one bridge can be active.

bridge stat clear

Resets the bridge statistics counter.

bridge stat display

Displays statistics on a specified bridge route. 
If “please use index first: ip route addrom index 
[index#]” 

appears, use the index command in this table to specify a 

bridge.

bridge stat freememory 

Frees the current working buffer. After using this command you can then 
select a bridge route to display or edit.

bridge stat index <entry#>

Specifies a bridge route (1-4) to display or edit. Use freememory before 
specifying a bridge route different from the current one.

bridge stat name <string>

Sets a name for the bridge specified with the index command (10 
characters).