ZyXEL Communications n/a 用户手册

DSL & IAD CLI Reference Guide

Use these commands to configure the settings of Ethernet ports on ZyXEL Device.

The following table describes the values required for many commands. Other values are 
discussed with the corresponding commands.

The following section lists the commands for this feature. Not all commands are available on 
all models. 

Table 24   Ethernet Command Input Values

This is a channel name, for example in a DSL product with WLAN and DMZ, the 
LAN is enet0, the WLAN is enet1 and the DMZ is enet2. The channel varies 
by your ZyXEL Device model. 

Table 25   Ethernet Commands

ether bridge

Displays whether or not bridge mode is enabled on the 
ZyXEL Device.

ether config

Displays the Ethernet configuration.

ether driver cnt disp <ch-name>

Displays the specified interface’s Ethernet statistics.

ether driver status <ch-name>

Displays the specified interface information, including 
the channel ID number and MAC address.

ether driver config 

[0|1=auto|normal] [0|1=10|100] 

[0|1=HD|FD] <ch-name>

Sets an interface’s connection speed and duplex mode. 
This command is for a ZyXEL Device with one Ethernet 
LAN port only.

ether driver qroute

Displays the current quick route setting.

ether driver qroute 

[0:Off|1:ISR|2:Task]

Disables or enables quick routing in ISR (Interrupt-
related System Register) mode or task mode to speed 
up routing. 
In ISR mode, the ZyXEL Device generates an interrupt 
signal when receiving a packet. In task mode, the ZyXEL 
Device creates a task to handle the received packets. 
By default, quick route is enabled in task mode in the 
ZyXEL Device.
This command is configurable only on system reboot.

ether edit load <ether-no>

Loads the Ethernet configuration for the specified 
interface.

: 1:LAN, 2:WAN, 3:DMZ, 4: WLAN