DELL D600 用户手册

Enable the Pointing Device option in the system setup program. If the problem persists, 

. 

 

 

Ensure that you have spelled the command correctly, put spaces in the proper place, and used the correct 

pathname. 

 

 

. 

 

 

The CD drive does not respond to commands from the computer. See "

." 

 

 

The floppy or hard drive cannot read the data. See "

." 

 

 

One or more memory modules may be faulty or improperly seated. Reseat the memory modules and, if 

necessary, replace them. See "

." 

 

 

The hard drive failed initialization. Run the Hard-Disk Drive tests as described in "

." 

 

 

The system configuration information may not match the hardware configuration. Run the Diskette tests as 

described in "

." 

 

 

The floppy disk may be defective. If the drive access light turns on, try a different disk. See "

." 

 

 

 

 

Because the floppy disk is write-protected, the operation cannot be completed. Slide the write-protect notch. 

 

 

The operation requires a floppy disk in the drive or a hard drive in the bay before it can continue. Insert a floppy disk, or 

 in the hard drive bay. 

 

 

The computer cannot identify the PC Card. Reinsert the card or try another PC Card. 

 

 

The amount of memory recorded in NVRAM does not match the memory installed in the computer. 

Restart the computer. If the error appears again, 

. 

 

 

A memory module may be loose. 

 and, if necessary, replace them. 

 

 

The operating system is unable to carry out the command. The message is usually followed by specific information—for 

example, Printer out of paper. Take the appropriate action. 

 

 

, and boot 

the computer from a bootable floppy disk or CD. Then turn off the computer, reinstall the hard drive, and restart the computer. Run the Hard-
Disk Drive tests as described in "

." 

 

 

computer. If the problem persists, try another drive. Run the Hard-Disk Drive tests as described in "

." 

 

 

The hard drive does not respond to commands from the computer. Turn off the computer, 

and boot the computer from a bootable floppy disk or CD. Then turn off the computer, reinstall the hard drive, and restart the computer. If 
the problem persists, try another drive. Run the Hard-Disk Drive tests as described in "

." 

 

 

, and boot the computer from 

a bootable floppy disk or CD. Then turn off the computer, reinstall the hard drive, and restart the computer. If the problem persists, try 
another drive. Run the Hard-Disk Drive tests as described in "

." 

 

 

The operating system is trying to boot to a nonbootable floppy disk or CD. Insert a bootable floppy disk or CD.