Royal Sovereign RSC-1650HR 用户手册

16

15

Installation of the Front Feeder Option (Includes 2 brackets,

one spindle, and mounting hardware).

1. Install the Front Feeder to the inside of the front frames

using four 1/4"(M6) hexagon bolts on each side (Figure 1)

Installing the Rear Rewinder Option (Includes motorized

winder, bracket, one spindle, and mounting hardware). 

1. Remove the left and right covers by using a Phillips

screwdriver (four screws on each side cover) (Figure 2 &

3).

2. Remove the lever knob screw and lever (Figure 4).

3. Remove the rear cover by removing all 

10 screws (4 top, 4 bottom, and 1 on 

each side) (Figure 5 & 6).

4. Disassemble the power switch bracket and place the left

rewinder outside of the frame; fasten with round head

3/16"(M5) screws (included in the option kit).  Then,

reinstall the power switch bracket (Figure 7).

5. Install the right rewinder on the outside of the frame and

connect the motor wire connector  to the rear wire 

(Figure 8 & 9).

6. Reinstall the rear cover.

7. Reinstall the side covers.

8. Reinstall the lever knob and screw.

Note: Below options are to be installed by an authorized RS reseller.

Figure  1

Figure  7

Figure  8

Figure  9

Figure  2

Figure  3

Figure  4

Figure  6

Figure  5