Xerox 5225A 用户手册

233

This chapter describes how to set up the printing environment for the machine. Some 
models require a Printer Kit to use the print feature on the machine.
The following information is provided:

Windows TCP/IP – page 233
NetWare – page 236
UNIX TCP/IP – page 240
EtherTalk – page 257
Microsoft Networking – page 259
TCP/IP (LPD or Port9100) – page 263
USB Port – page 267
IPP (Internet Printing Protocol) – page 270

This section explains how to set up the machine to operate in a Windows TCP/IP 
environment. The following information is provided:

Quick Network Setup (DHCP) – page 233
Quick Network Setup (Static IP) – page 234

Confirm that an existing operational network utilizing TCP/IP is available.

Confirm that the Ethernet cable is plugged into the multifunction machine and into 
an operational Ethernet port on the network.

NOTE: The Ethernet cable is an RJ45 type and is not supplied by Xerox.

On startup, the multifunction device defaults to DHCP to obtain its network 
configurations. A DHCP server delivers an IP address, as well as other configuration 
settings to the machine. If you use a DHCP server to allocate an IP address to the 
machine, then proceed as follows:

Power on the machine.

Wait a minute or so while the machine negotiates an IP address.

Print the Configuration Report.

1) Select the <Machine Status> button on the machine.
2) On the [Machine Information] screen, select [Print Reports].
3) Select [Printer Reports].