X10 Wireless Technology SC1200 用户手册

 

 

PLEASE WAIT

SPEAK NOW

PLEASE WAIT

4. MESSAGE

1. INSTALL

****
12:00 am

ENTER PIN
12:00 am

Press either of the Menu up/down buttons (under the lid to the bottom right of the display). 
The display then shows ENTER PIN (Personal Identifi cation Number) in the top line. 

The default PIN is 0000, you’ll fi nd out later (page 24) how you can change this, but for 
now press 0000 on the keypad (under the lid to the bottom right of the display). This  clears 
the top line and shows * for each number entered. 

This takes you to the fi rst level of the menu at step 1. This is the INSTALLATION level. The 
display looks like this:

Press an up or down menu button until you reach the MESSAGE menu, and then press 
OK to go to the screen below (or press 4 to go into the MESSAGE menu ):

Press 1 or 2 to select one of the options below:

1. RECORD  (This is your own alarm message).
2. REPLAY (This replays a previously recorded message).

Press 1 for RECORD , then press OK. The display shows:

Then:

Clearly speak your message into the Console’s microphone (up to 12 seconds max.).  
A typical message could be: “There’s an alarm in progress at (your address), at the end of 
this message please press any button on your touch-tone phone to listen in.” After you’ve 
fi nished speaking (12 seconds max), wait for the display shown below:

1. RECORD
2. REPLAY

Now press 2 for REPLAY the display shows:

It then plays back your recorded message. Wait for the display shown below:

1. RECORD
2. REPLAY

Press Clear to back out of the menu. You are asked to confi rm,  1. YES, 2 NO.  Pressing 1 
takes you back to the HOME CONTROL screen. Pressing 2 stays in the INSTALL mode.

Note: you cannot record messages remotely via telephone.

1. RECORD
2. REPLAY