X10 Wireless Technology SC1200 用户手册

 

 

If you do not hear a beep from the 
Console when you register a Door/
Window Sensor or Motion Detector.

With the Console NOT armed check that 
it chimes when you press TEST on the 
Door/Window Sensor, or the alarm trips 
when you press test on a Motion Detector 
(when the system IS armed). If it does, 
then the sensor is already installed and no 
further action is necessary. If not:

•  Reregister the sensor/motion detector 

(see Setting Up Door/Window Sensors 
and Setting Up Motion Detectors. 

If the battery indicator on the Console is 
on.

Replace the Console’s batteries. Four AA 
alkaline batteries provides approximately 
12 hours of backup. Replace batteries at 
least once a year.

If you lose your remote control.

Reinstall your complete system to prevent 
someone else from using the lost remote 
control. See bottom of page 39.

If the system Arms or Disarms by itself

A neighbor may have a compatible 
system. Reinstall the complete system so 
that it chooses different RF codes. See 
bottom of page 39.

If the light on the Keychain Remote stays 
on during initialization.

Remove the batteries, press a button 
for a few seconds, release, then replace 
the batteries. Press and hold  the ARM 
button on the Keychain Remote for a 
few seconds and then release it. This 
initializes the remote and picks a random 
code that is used when it is registered with 
the Console. Reregister the remote.

You open a door or window and the alarm 
does not trip.

•  Check that the system is armed.

•  Check to see if the alarm trips when 

you press TEST inside the Door/
Window Sensor.

•  If the alarm does not trip when you 

press TEST, check that the indicator on 
the sensor comes on when you press 
TEST.

If the indicator does not come on, replace 
the batteries and reinstall the sensor if 
necessary.

If appliances turn off during an alarm.

The system fl ashes lights by repetitively 
transmitting the SECURITY light on and 
off codes. 

Any Appliance Modules set to the same 
codes will therefore turn on and off.

If you do not hear a beep from the 
Console when you press ARM to install a 
Remote.

•  Re-initialize the remote (see page 12).