X10 Wireless Technology SC1200 用户手册

 

 

1. INSTALL
ZONE 13 OUT

CLEAR ZONE
1. YES  2. NO

1. INSTALL
ZONE

•  Attach the Door/Window Sensor to the wall using the mounting screws provided. 
•  Fit the Door/Window Sensor as high as possible at the top of the door/window. 
•  Make sure the arrows on the magnetic and the Door/Window Sensor are facing each 

other and that they separate cleanly when the door or window is opened. 

•  To protect two doors or windows close to each other, use the Door/Window Sensor with 

an additional set of magnetic switch contacts as shown in the diagrams above.

•  Set the DELAY slide switch (inside the Sensor) to MIN to always trigger the alarm 

instantly (for windows), or to MAX to trigger the alarm after a preset entry delay when the 
system is armed in the AWAY mode (for doors).

The numbers 1 – 32 in the display refer to up to 32 “zones.” These represent up to 30 
Door/Window Sensors and/or Motion Detectors you install, plus the 2 hard wired zones.  
The numbers show open zones, problem zones and bypassed zones by being displayed 
as steady on (door or window open), slow fl ash (there’s a problem with that zone) or fast 
fl ash (that zone has been bypassed).  Attempting to arm with an open or problem zone 
makes the Console beep continuously and it will display in words on the display what the 
cause is, but only for one zone at a time.  Bypassing that zone (by pressing the Clear 
button) moves on to the next problem zone, if there is one.  

Now move the magnet away from the Door/Window Sensor. The Console acknowledges 
that it has been registered with a chime and by displaying ZONE 1 SET.

Repeat this for any other Door/Window Sensors you want to register. The display 
increments to ZONE 2 SET, etc., as you install more Door Window Sensors. If you 
connected a second magnetic switch to the contacts on the sensor (as shown on the next 
page) move its magnet away to install the second magnetic switch as a separate zone.

If desired, you can specify what zone you want the Door Window Sensor to be registered 
into. Just press the number of the zone you want on the Console’s keypad, before you 
register the Door Window Sensor.

Press Clear to back out of the menu. After a short delay the display reverts to showing 
HOME CONTROL on the top line and the time of day on the bottom line.

Follow the steps above to install a sensor. Then when the display shows:

Press the number of the zone you desire (just as if you were going to register the Door/
Window Sensor into that zone) but instead of registering the Door/Window Sensor, press 
CLEAR on the Console’s keypad. The display asks you to confi rm the deletion:

Pressing 1 on the Console’s keypad changes the display to:

Remove shorting link 
before installing hard 
wired magnetic contacts.

Where 13 is the zone you selected. Pressing 2 instead takes you back to the INSTALL 
ZONE screen. 

Press Clear to back out of the menu. You are asked to confi rm,  1. YES, 2 NO.  Pressing 
1 takes you back to the HOME CONTROL screen. Pressing 2 takes you up one level of 
menu.