DMP Electronics XR10 用户手册

Disarming: While the system is armed, you can only enter the
premises through an entry/exit delay door without causing an alarm.
After opening the door, the Security Command  keypad  sounds a
prewarn tone to remind you to disarm the system. You must disarm
the system before the prewarn tone expires or an alarm on the door
zone will occur.

During the prewarn tone, the keypad displays ENTER CODE:. Enter
your security code to disarm the system.

Alarm Display: After disarming, the keypad displays any zones that
tripped or any transmission problems that occurred during the armed
period. All burglary zones are then disarmed and any bypassed
zones are automatically reset.

Disarmed Message: The keypad displays ALL SYSTEM OFF after
the system disarms.

Central Station Report: A report of the system disarming can be
transmitted to the central station. This is optional and can be
programmed for you at any time.

1. During the entry delay time, the keypad displays ENTER CODE:

. Enter your security code number.

2. The keypad then displays any zones that went into alarm or any

communication problems that occurred during the armed period.

3. The keypad next displays ALL SYSTEM  OFF to confirm the

system is disarmed.

1. While the alarm bell or siren is sounding, enter your security code

number. The keypad displays DISARM    SILENCE.

2. Press the SELECT key under DISARM to disarm the system and

silence the alarm.

The keypad next displays ALL SYSTEM  OFF to confirm the
system is disarmed.

3. Press the SELECT key under SILENCE to stop the bell or siren

but NOT disarm the system. Selecting SILENCE sends a Bell
Silenced report to the central station.

4. If your system is programmed to send an Abort (alarm cancel)

report to the central station, the keypad displays ALARM
CANCELLED.

If you do not press any SELECT key while DISARM   SILENCE is
displayed, the system automatically selects DISARM and disarms
the system.