Lenmar Enterprises Camcorder & Digital Camera 产品宣传页

 

 

 

 

PLEASE READ THE INFORMATION AND FOLLOW ALL INSTRUCTIONS 
THOROUGHLY BEFORE USING THIS PRODUCT.  
 

The OmniSource Power System is a complete AC Power Supply/Charger 
solution for use with many popular cameras and camcorders. The 
Universal AC “switching” power adapter works with 100V –240VAC to 
allow for trouble free use domestically or overseas. The power adapter 
can be plugged directly into the camcorder or camera for virtually 
unlimited record time, or plugged into the included charger module to 
charge batteries conveniently, away from the camera. 

 
 

•  100-240V switching AC power adapter for use domestically and 

overseas. 

•  Plugging your camera into the power adapter provides unlimited 

operating time without requiring an on-board battery. 

•  Allows you to recharge your battery with the included charger 

module, leaving the camcorder/camera free for use. 

•  Charger module includes 2-color LED charge status indicator - RED 

(charge) / GREEN (full). 

 

 

1.  Plug the end of the AC power adapter cord into the 

camcorder/camera. Often, this connection will be identified on the 
camcorder/camera as “DC IN”. Make sure the connector from the 
power adapter fits the camcorder/camera properly. If it does not, it 
may be the wrong type for your camcorder/camera. Once the power 

adapter has been properly plugged into the camcorder/camera, plug 
the AC power adapter into the wall. Power up the camcorder/camera 
and operate as you would normally. Many new camcorders and 
cameras will charge the batteries on the camera unit itself. For these 
units, simply follow the directions supplied from the manufacturer 
while the camcorder/camera will be powered by the OmniSource 
Power System. The battery will charge just as it would when plugged 
into the manufacturer supplied power adapter.  

2.  When you wish to disconnect the power adapter, first turn the 

camcorder/camera unit off then unplug the power connector. 

 
 

 

IMPORTANT WARNING: 
This CHARGER MODULE is for charging rechargeable Li-Ion batteries 
ONLY! Attempting to charge any other type batteries may damage the 
device, destroy the batteries and/or cause personal injury.  
 
1.  Plug the connector at the end of the AC power adapter cord into the 

charger module, then plug the adapter into the wall socket. With 
power present, the LED on the top of the charger module will glow 
GREEN.  

2.  Slide your Li-Ion battery into the charger module, making sure the 

battery has proper connection with the charger module contacts. The 
LED indicator in the charger module will turn RED to indicate your 
battery is receiving fast charge. As soon as the battery is fully 
charged, the LED indicator will turn GREEN to indicate your battery is 
ready for use. Once the battery is full, remove the battery from the 
charger module and unplug the power adapter and charger module. 

•  It is normal for the switching AC power adapter, charger cradle and 

battery to become warm during charge or regular operation.   

•  If the charger does not charge the battery, check to see if the battery 

was already fully charged, is dead, faulty or worn out. All 
rechargeable batteries will eventually wear out after being charged for 
a certain numbers of cycles.  

•  Always keep metal contacts on both charger and battery clean. If 

cleaning is necessary, wipe the contact surfaces with a dry, soft and 
clean cloth.