D-Link 1000BASESX/LX 用户手册
7
fiber was turned to forced mode, and “Off” for
auto-negotiation mode.
auto-negotiation mode.
Note: Be sure the opposite end is using the same setting(forced or Auto-negotiation).
And when using two converters at the same time, the two converters MUST set to
forced mode.
And when using two converters at the same time, the two converters MUST set to
forced mode.
Switch 2: LLR
When the switch was turned to “On”, it means that the
LLR was enabled and “Off” for disabled.
When the switch was turned to “On”, it means that the
LLR was enabled and “Off” for disabled.
Note: When using two converters at the same time, then only one converter need to
enable the LLR function.
enable the LLR function.
S
PECIFICATIONS
Standards:
IEEE802.3ab 1000BASE-TX
IEEE802.3z 1000BASE-SX/LX
IEEE802.3z 1000BASE-SX/LX
Data Transfer
Rate:
Rate:
1488000pps for 1000Mbps
Duplex Mode:
Full Duplex Mode
LED indicators:
PWR, LNK/ACT
Media Interface:
RJ-45, SC
EMI
Compatiblity:
Compatiblity:
FCC Class B
CE Certification, Class B
VCCI Class B
CE Certification, Class B
VCCI Class B
Temperture:
Storage: -10
°C ~ 70°C
Operating: 0
°C ~ 40°C
Humidity:
10% ~90% non-condensing
Power
Consumption:
Consumption:
5.5 Watts (maximum)