National Instruments PXI-1006 User Manual 用户手册
© National Instruments Corporation
1-1
1
Installing and Verifying Operation
This chapter describes how to unpack the PXI-1006, install a controller,
and verify that the chassis is operating correctly.
and verify that the chassis is operating correctly.
Unpacking the PXI-1006 and Installing a Controller
This installation example assumes you are using an embedded PXI
controller.
controller.
1.
Unpack your PXI-1006 chassis.
2.
Make sure the power switch is in the Standby (Off) position.
3.
Plug in the AC power cord.
Power cords are available from National Instruments, or use a power
cord that meets the requirements of ANSI/UL817 for use in the United
States, CSA C22.2 21 and 49 for use in Canada, and IEC 227 or 245
for use in the European Union. AC mains power supply cords used
with the PXI-1006 in other countries must be approved by the authority
having jurisdiction in that country.
cord that meets the requirements of ANSI/UL817 for use in the United
States, CSA C22.2 21 and 49 for use in Canada, and IEC 227 or 245
for use in the European Union. AC mains power supply cords used
with the PXI-1006 in other countries must be approved by the authority
having jurisdiction in that country.