Datalogic Scanning Memor 用户手册

DATALOGIC MEMOR™ 

 
To capture data first of all select the barcode icon on the bottom-right side of the 
display and tap the 'Capture' menu item then proceed with the following 
directions. 
To configure and enable data capture parameters refer to par. 3.5. 
 

 
To scan barcodes, point the Datalogic Memor™ laser model onto the code from 
a distance within the reading range while pressing the SCAN key. 
 
The lighted band emitted by the laser must completely intercept the barcode as 
shown in the figure below. If enabled, the emission of an acoustic signal will 
indicate that the scan has taken place correctly.