DISH Network 612 用户手册

To use the remote control to operate other devices (such as a TV, VCR, DVD player, 
tuner, amplifier, or DISH Network satellite receiver), you must first program it to operate 
these other devices. You can do this by either following the instructions in Setting Up 
Using Device Code Tables on page 67, or the Setting Up Using Device Codes Scan 
procedure described on page 68. 

Use the remote control’s mode buttons, SAT (satellite receiver), TV (for a TV), VCR (for a 
VCR or a DVD player), and AUX (“auxiliary,” for a second TV, a VCR, a tuner, an audio 
amplifier, or a second DISH Network satellite receiver) to set the remote to the correct 
mode for the device. To change the mode, press the button for the device you want the 
remote to operate. The mode button lights for two seconds to show you’ve set the remote 
to that mode.

You can program your remote control in Limited Mode to keep from accidentally changing 
the channel on your TV or VCR and causing a snowy or blue screen. When the remote 
control is in Limited Mode for TV mode, you will only be able to use POWER, MUTE, and 
VOLUME functions for your TV. When the remote control is in Limited Mode for VCR 
mode, you will only be able to use POWER and the VCR functions for your VCR.

Note: Limited Mode is not used with amplifiers.

1

Press and hold the correct mode button (for example, TV) until all of the mode buttons 
light. Release the mode button.

2

Press:

PAGE UP to turn Limited Mode on.

PAGE DOWN to turn Limited Mode off.

3

Press POUND (#). 

If you are programming the remote to operate a combination device, such as a TV/VCR or 
a TV/DVD, program the remote control in one mode, and then repeat the procedure in the 
other mode. For example, to program the remote to control a TV/VCR using code 748, 
follow the instructions to program the remote to control the TV using code 748, and then 
repeat the instructions for the VCR using the same code.