DISH Network 612 用户手册

1

Turn on the other receiver and display the System Info screen as described in that user’s 
guide.

Write down the remote control address: 

2

Press and hold AUX until all the other mode buttons light up, and then let go of the button. 
AUX flashes.

3

Press the 3 button.

4

Use the NUMBER PAD to enter the address you wrote in step 1.

5

Press POUND (#). AUX blinks three times.

6

Press RECORD to ensure the address in the remote matches the address on the receiver.

Use RECOVER if you accidentally change the TV channel or video input and have a 
snowy, blue, or black screen on your TV. When you press RECOVER as described below, 
the remote control sends commands to your TV to change channels or video inputs to get 
back to watching satellite programming. This procedure works only if you have 
accidentally changed the TV channel or video input. It does not recover lost satellite signal 
(see Troubleshooting Tables on page 100 for information on solving problems).

Note: The remote control must be programmed to operate the TV (and VCR, if applicable) 
for RECOVER to work as described. RECOVER will first try to tune your TV to channel 3, 
then channel 4, and then other video inputs with each press of RECOVER. You may need 
to press RECOVER multiple times to recover your satellite TV video. 

To use RECOVER, the remote control must be programmed to operate the TV and, if 
installed, the VCR. 

1

2

3

5

4

6