Vidikron VP-6500VHD 用户手册
Vidikron PlasmaView Owner’s Operating Manual
29
PRE
L
IMINAR
Y
4.3
Using the VHD Controller
Menus
Using the VHD Controller
Menus
Press the MENU button on either the remote control or the VHD Controller front panel to
display the Main Menu. To select a menu item, use the UP (
display the Main Menu. To select a menu item, use the UP (
) and DOWN (
) buttons on
either the remote control or the VHD Controller front panel to highlight it. Press ENTER to
confirm your selection.
confirm your selection.
The PlasmaView OSD menus are arranged hierarchically, as shown in Figure 4-1. Depending
on the selected input source and signal characteristics, some menu options may not be
available.
on the selected input source and signal characteristics, some menu options may not be
available.
1. The native resolution of the VP-6500VHD is 1920 x 1080. Other
horizontal or vertical resolutions may be scaled upward or downward
to fit the display.
to fit the display.
2. With most computers, you can get the best picture at 1024 x 768 @
60Hz.
To prevent image retention (burn) on your display, ALWAYS use a screen
saver and set it to the shortest possible time.
saver and set it to the shortest possible time.
Note
WARNING
When the input signal resolution is 1080i analog (via the HD1 or HD2
input) or lower, the menus appear both on-screen and on the front-panel
display of the VHD Controller as you navigate them:
input) or lower, the menus appear both on-screen and on the front-panel
display of the VHD Controller as you navigate them:
When the input signal resolution is 1080i digital or 1080p (via the HDMI1
or HDMI2 input), the menus appear on the front-panel display only.
or HDMI2 input), the menus appear on the front-panel display only.
Note
Input Source
Aspect Ratio
↑
↓
↓