Metz 20 TM 52 用户手册

- 52 -

Personal Preferences (

)

All the preset values will be restored, when
pressing "

Sound Indicator

The alternatives of the indicator are Mono,

Stereo, Dual I and Dual II. This indicator is

displayed under the programme number in-

dicator on the screen. "I-II" button is used to

select Mono or Stereo, or Dual I or Dual II.

0212

In Mono broadcast or in forced-mono (for

stereo broadcast).

67(5(2

In Stereo broadcast.

'8$/,

If dual broadcast detected. Dual I is selected

in default and also can be selected after

Dual II by Remote Control.

'8$/,,

If Dual II selected by Remote Control.

Picture Mode

Picture mode OSD is displayed when

button is pressed. Picture mode can be

changed to Auto, 4:3 or 16:9 by pressing

button.

Sleep Timer Indicator

It is displayed on the upper right of the

screen when a new programme is entered
by digit button or by pressing

, P-,

P+, TV, AV button. If sleep timer is acti-

vated it is displayed with the TV status and

erased with it after 3 seconds.
After the setting time of sleep timer has

passed then TV goes automatically to stand-

by.

Mute Indicator

It is placed in the upper middle of the screen

when enabled, and it stays there until it is

disabled.

To cancel mute, there is two alternative; the
first one is pressing to " " button, this vol-

ume is set to the preceding value, and the

second one is increasing the volume level,

thus it starts at the minimum level to in-

crease. By decreasing the volume level in

mute state, mute will not be ignored, only the

volume level will decrease. If mute canceled

after decreasing the volume level, the vol-

ume will valid with the decreased level.

No-Signal Detection (TV)

If no valid signal detected, it takes 5 minutes

for the switching to the Stand-By mode un-

less any signal detected or no any Remote
Control command is accessed.
After a Remote Control command (if No-Sig-

nal Timer is active) the timer stops and if no

signal detected again the timer is initialized

to 5 minutes and starts 3 seconds later

again to count down.
It is not valid in AV mode.

No-Signal Detection (PC)

If no valid signal detected for 5 minutes sys-

tem goes to Stand-By mode. To switch on
the system press button.

As the last status feature, system starts from

TV or PC, whichever was the status before

stand-by or switch-off. Note that SCART in-

puts have the precedence on both TV and

PC.