Fujitsu PDS4222W-S 用户手册
E-13
English
Setting signals
This display can store parameter settings for eight additional signals for both RGB1 and RGB2.
To do this, select a desired signal and follow the instructions in “Adjusting Screen Position and Size” on P. E-30–E-31 to adjust the
parameters. When you finish, the settings will be automatically stored. Thus, when the display receives that signal, images will be
displayed in accordance with the settings you most recently selected.
parameters. When you finish, the settings will be automatically stored. Thus, when the display receives that signal, images will be
displayed in accordance with the settings you most recently selected.
This display has been factory-set to provide screen setting values for seven different signals (see Table below).
Factory-set signals (RGB1, RGB2 modes)
• “The applicable frequency range” appears if the display receives a signal whose characteristic does not fall within the display’s permissible range.
• You can check input signals through “Status” on the OTHERS Menu screen. (See P. E-34–E-36.)
• All terms (i.e., company and product names) used in this document are trademarks or registered trademarks.
Factory-set signals (Comp.video mode)
852 x 480
31.72
59.97
When a dedicated graphics card is used
640 x 480
31.47
59.94
VGA
640 x 400
37.88
60.32
SVGA 60 Hz
1024 x 768
48.36
60.00
XGA 60 Hz
848 x 480
31.02
60.00
640 x 480
15.73
59.94
60 fields
640 x 480
15.63
50.00
50 fields
User setting
15.63 to 80.00*
50.00 to 120.00*
(eight varieties each for
the RGB1 and RGB2
modes)
the RGB1 and RGB2
modes)
Signal
Display (dots x lines)
Horizontal frequency (kHz)
Vertical frequency (Hz)
15.73
59.94
SDTV 525i
15.63
50.00
SDTV 625i
31.47
59.94
SDTV 480p
45.00
60.00
HDTV 720p
44.96
59.94
HDTV 720p
33.75
60.00
HDTV 1080i
33.72
59.94
HDTV 1080i
Horizontal
frequency (kHz)
Signal
Vertical
frequency (Hz)
Factory-set signals (Video, S-video mode)
15.73
59.94
NTSC
15.63
50.00
PAL
15.63
50.00
SECAM
15.73
59.97
4.43NTSC
15.73
59.97
M-PAL
15.63
50.00
N-PAL
Horizontal
frequency (kHz)
Signal
Vertical
frequency (Hz)
* With some input signals, “Out of range” may appear even when the horizontal and vertical frequencies are within their permissible ranges. Images
may become blurred, and the message “Change refresh rate to 60 Hz” may appear if the vertical frequency is outside the 48.3 to 51.8 or 58.4 to 61.4
Hz ranges. In this case, change your PC settings.
Hz ranges. In this case, change your PC settings.
In the Comp.video and Video/S-video modes, the display has been factory-set as follows for different input signals: