Hitachi DZ-BD10HA 用户手册

• Use a disc which is not dirty, scratched, or warped. (BD/DVD)
• A Hitachi Maxell disc is recommended. (BD/DVD)
• Do not use the camcorder in a place where the humidity is high or the temperature is 

very low.

• If there is concern that the camcorder may be subjected to large vibrations or impact 

during transport, remove the BD/DVD/Card and protect the camcorder using soft 
protective materials.

• When the camcorder is subjected to an impact while a BD/DVD disc is loaded, a mark 

may form on the disc surface due to the impact protection function for the disc and 
pickup. This mark can be wiped off using a dry soft cloth.

• Be careful when removing the disc since the metal of removal slot of camcorder, and 

disc itself, may be hot.

• For card handling, see p.22.

• If the camcorder is not used for long periods of time, remove the disc from the 

camcorder.

• When storing disc, replace it in the plastic case in which it was purchased.
• Be careful that no condensation occurs on disc.
• Do not place disc in following places:

− Direct sunlight for a long time

− Where humidity is high or in dusty place

− Where there is heat from a heater, etc.

If the above countermeasures are not taken, the following symptoms may occur:

− Block noise in playback image, 

momentary stop of playback image

− Sound interrupted during playback, or 

abnormal sound

− Blue thumbnail display* (Fig. 1)

− Disc cannot correctly be recognized

− Disc cannot be initialized

− Recording/Playback is not possible

z Disc Cleaning

• Use a dry soft cloth to lightly wipe off any dirt adhering to the disc as shown in the 

figure. Do not wipe the disc with force: Doing so could cause scratches.
Never use solvent (thinner, water, antistat or detergent) for cleaning.

0010/0027 

10/ 1/2008 10:10:10 AM

SELECT 

All Scenes 

PLAY

EXIT 

SEL

Block noise

Fig. 1

*