JVC DR-MH20S 用户手册

Masterpage:Right+

Filename [DR-MH30US_09Editing.fm]

Page 61

Thursday, 8 July 2004  15:30

You can use a camcorder as the source player and your unit as the 
recording deck.

Make connections.

A If the camcorder has no S-VIDEO output connector:
— connect the camcorder’s AUDIO/VIDEO OUT connectors to the 
unit’s AUDIO/VIDEO input connectors on the front panel.

● When using a monaural camcorder, connect its AUDIO OUT 

connector to the AUDIO L input connector on your unit.

B If the camcorder has an S-VIDEO output connector:
— connect the camcorder’s AUDIO OUT and S-VIDEO OUT 
connectors to the unit’s AUDIO and S-VIDEO input connectors on 
the front panel.

Press HDD or DVD repeatedly to select the recording deck.

Press CH +/– to select “F-1”.

● Set “FRONT AUX F-1” to “VIDEO” for the VIDEO input connector, or 

“S-VIDEO” for the S-VIDEO input connector, depending on the 
connector being used. (

Press REC MODE repeatedly to set the recording mode.

Start playback on the camcorder slightly before the actual point 

from where you wish to start dubbing.

Press 7 on the unit to start recording. Or press and hold 7 and 

press 4 on the remote control. The dubbing starts.

Press 8 on the unit, then stop playback on the camcorder.

● All necessary cables can be obtained from your dealer.

● Refer to the camcorder’s instruction manual for operating procedure.

● The quality of dubbed picture becomes poorer than that of the 

original.

A If the camcorder has no S-VIDEO output connector:

AUDIO/VIDEO input

Audio/video cable

(not provided)

AUDIO/VIDEO OUT

B If the camcorder has an S-VIDEO output connector:

S-VIDEO input

AUDIO input

S-video cable

(not provided)

AUDIO OUT

Audio cable
(not provided)

S-VIDEO OUT

● Slide the TV/CABLE/DBS/DVD switch to DVD.

DR-MH30US_00.book  Page 61  Thursday, July 8, 2004  3:32 PM