GE BusSecure 用户手册

Hardware Installation 

BusSecure User Manual 

 

10 

0150-0263A / May 2003 

The BusSecure system will support up to four cameras (color and/or monochrome). Cameras supported 
by the BusSecure system can provide a 1.0 V pk-pk composite analog video signal, either NTSC or PAL, 
at 75 ohm (CCTV standard). 

Surface-mount camera housings are typically mounted to the ceiling, but can be mounted to any flat 
vehicle surface. 

Note: In some installations, it is necessary to use a metal tapping plate behind the mounting surface. If a tapping plate is used, 
prepare it in the same way as the mounting surface (i.e., drill a cable entry hole and mounting holes in the appropriate locations). 

1)  Use the template in Appendix A to mark the location of the 

cable-entry hole and two mounting holes. See Figure 4. 

2)  Using a 3/16-inch (5 mm) (drill bit, drill the two mounting 

holes. 

3)  Using a 1-inch (25.4 mm) drill bit, drill the cable entry hole. 

4)  Install a 3/4-inch (20 mm) (interior diameter) grommet on 

the cable entry hole, or where feasible. 

5)  Connect the video and power cables to the camera,  

and feed the excess cable into the vehicle’s duct area. 

6)  Mount the camera and mounting plate to the vehicle  

surface (and tapping plate, if used). See Figure 5. 

7)  Refer to section 2.4.3 to align the camera’s field of  

view to the appropriate angle. 

8)  Secure the surface-mount housing to the mounting  

plate with the four 3/8-inch tamper-resistant  
tamper-torque machine screws provided, using a 
bit of blue locktite. See Figure 6.  

 

  Cable entry hole

 

  Mounting holes