Q-See DVR 用户手册

 

To configure the DVR's time:

 Press [    Up] and [    Down] to move

 prompt.

Press [    Select] to modify. 

Press [      Menu] to save and exit.

Q-See Q25DVR4ES User's Manual

 

If you choose YES, recording continues 

and overwrites previous recordings when

the hard drive is full. If you choose NO,

the recording process stops when the

hard drive is full. 

HDD SIZE: This shows the size of the 

hard drive installed in the DVR. 

HDD USED: This shows the space used 

up on the 

hard drive and the 

percentage of hard drive space being used.

master 

If you format the hard drive, it will erase all the data on the hard drive.

Note: When you install a new hard drive in the DVR, please use this 

function to format the hard drive.

 

Page 13

Page 14

Q-See Q25DVR4ES User's Manual

CHANNEL SENSITIVITY:
Press [     Select] to adjust sensitivity of motion 
detection on each channel.
High (1----------9,OFF) Low
When it's OFF, the channel cannot be triggered 
by movement.

  SET: 

       Press 

     Select

 to enter the sensitive area of each camera. The picture

 of the selected channel is divided into 144(12*12) blocks, press [REW] to 

move left, press [FWD] to move right, press [UP] to move up, press 

[DOWN] to move down, press [     Select] to set the block to being active or not. 

      When the block is transparent, it's active to record. When the block is 

covered by shadow, it is not active, and motion in this area will NOT be recorded.

Make sure Record Schedule is set to Motion for the times required.

[     Menu], and press [    Record] to start Motion Recording.

This number indicates how long the triggered 
recording lasts after the DVR has been triggered by
 motion.

 

This number indicates how long the buzzer inside 
the DVR will sound when a motion event has been 
detected.

 

User needs to have video record method set to 
Motion Trigger. (Refer to 5.7 Schedule Set)