Sanyo DSR-3506P 用户手册
GENERAL SET
4
English
77
3
Turn the shuttle dial clockwise.
“ON” for the (1) “DATE” flashes. This can be set to “OFF”
turning the jog dial to remove the date from the operation
display area.
turning the jog dial to remove the date from the operation
display area.
4
Turn the shuttle dial clockwise.
The cursor moves to the time entry.
The following settings are carried out using the shuttle
dial and jog dial.
z
The following settings are carried out using the shuttle
dial and jog dial.
z
Vertical cursor movement: Turn the jog dial.
z
Cursor movement to the right: Turn the shuttle dial
clockwise.
clockwise.
z
Modification of values: Turn the shuttle dial clockwise,
and then with the setting value flashing, turn the jog dial.
and then with the setting value flashing, turn the jog dial.
z
Confirmation of values: Turn the shuttle dial clockwise.
5
Perform the following if so required.
(2) TIME (OFF):
Time is not displayed during recording or playback.
(3) QUALITY (OFF):
Picture quality mode is not displayed during recording
or playback.
or playback.
(4) AUDIO (OFF):
Audio recording settings are not displayed during
recording or playback.
recording or playback.
(5) ALARM COUNT (OFF):
The current number of alarms is not displayed.
(6) ALARM TYPE (OFF):
The type of alarm recording is not displayed.
(7) TITLE (OFF):
Camera titles are not displayed.
The content of the operation display area
changes when the setting for “ALARM
RECORDING” (JP.68) from <ALARM REC
MODE SET> is switched.
changes when the setting for “ALARM
RECORDING” (JP.68) from <ALARM REC
MODE SET> is switched.
When turned “OFF”:
The alarm count and type are not displayed.
When turned “ENABLED”:
The operation display area changes as follows.
z
The alarm count and type are not displayed.
When turned “ENABLED”:
The operation display area changes as follows.
z
“ALARM” is displayed when alarm video is recorded or
played back.
played back.
z
“PRE” is displayed when pre-alarm video is recorded or
played back.
played back.
z
“ARCHIV” is displayed for playback from the archive area.
6
Press the [EXIT] button.
The setting procedure is ended and the display returns to
the normal screen.
the normal screen.
z
A maximum of 9,999 alarms can be displayed in the
operation display area. When this number is exceeded,
the count returns to 0000.
operation display area. When this number is exceeded,
the count returns to 0000.
Use the following procedure to display “VIDEO LOSS!”
when the camera video is interrupted.
when the camera video is interrupted.
1
Turn the jog dial to select “VIDEO
LOSS”, and then turn the shuttle dial
clockwise.
LOSS”, and then turn the shuttle dial
clockwise.
2
Turn the jog dial to display “ON”, and
then turn the shuttle dial clockwise.
then turn the shuttle dial clockwise.
3
Press the [EXIT] button.
The setting procedure is ended and the display returns to
the normal screen.
the normal screen.
z
After “VIDEO LOSS” is detected, it can be cancelled by
performing either of the following.
performing either of the following.
(1) Input a video signal.
(2) If no video input is required, use a [CAMERA
(2) If no video input is required, use a [CAMERA
SELECT] button to select the camera for which video
loss was detected and then press and hold the same
button.
loss was detected and then press and hold the same
button.
Setting display for video loss
EXIT
EXIT
e00_l8hbe_xe_7.book Page 77 Tuesday, April 27, 2004 10:35 AM