Winegard RM-DM61 用户手册

STEP 3. Remove backing from gasket. Attach 

adhesive side to base plate. IF YOU ARE 

USING THE ROOF WEDGE (RW-5000), use 

3/16” gasket included with the mount UNDER 

the roof wedge. Install the 1/16” gasket 

included with 

RW-5000 BETWEEN the mount 

and roof wedge.See Figure 7. 

Secure to roof using two mounting                         

screws provided. Check inside the vehicle.  

Be sure the shaft is centered in the hole.

Attach crank handle to shaft.                                 

Crank unit up until it stops.

STEP 4. Attach reflector to backup assembly, Figure 6.

STEP 5. Attach RS-1000 antenna to elevating tubes. 

Use the two E-clips and pins provided, Figure 6. Attach 

coax cable to F-jack on antenna and slide on weather 

boot, Figure 6.

STEP 6. Install remaining mount base screws. Install 

the vent tube on the back of the mount base. (This is the 

side opposite the word FRONT.) The hole for the vent 

tube is shown in Figure 8.
CAUTION: DO NOT seal hole in vent tube. Put sealant 

around the outside of the vent tube, approximately 1/2” 

from end, Figure 8. Push the vent tube into the hole. The 

sealant will seal the hole as you push in. Leave approxi-

mately 2 to 2-1/2” of the vent tube extending from the 

hole. Put a small amount of approved sealant on the roof 

and under the vent tube to hold in place.

STEP 7. Facing the front of the dish, find coax cables 

attached to side of the feed arm, Figure 9. Measure 24” 

of coax from this point and mark. DO NOT CUT. Rotate 

mount on base clockwise, fully, until it stops. Route coax 

around mount base, Figure 10.
Fasten cable clamp in hole in mount base (check roof 

template inserted in this manual for correct location) at 

end of the coax cable measurement. 

STEP 8. Feed coax cables through the roof. Weather-

proof cable entry by applying sealant under the lip of 

the cable-entry plate and where cable enters roof. Attach 

plate to roof with screws provided. Apply sealant over 

screws and around edge of roof-through plate, making 

sure cable entry is sealed. Secure cables as necessary 

to prevent whipping. 

7, page 6.
STEP 9. Apply approved sealing compound to screw 

heads, cable entrance hole and edge of gasket under 

mount, 

AFTER mounting, Figure 7.

STEP 10. Attach satellite coax cable (with RG-6 printed 

on it) to the satellite receiver.
STEP 11. Attach RS-1000 coax downlead (with RG-59 

printed on it) to RV-7542 power supply. Refer to power 

supply instruction sheet. You can connect the antenna 

Base plate

6-1/8”

Travel Bracket

output from the power spply directly to the “TV ANT IN” on 

satellite receiver. (Refer to receiver manual.) This allows 

you to watch local channels when you turn off the receiver.
STEP 12. Connect digital elevation sensor at roof level, see 

top of page 8.

ENTRY PLATE: Attach cable to roof using cable clamp. 

Use sealant to seal screw heads.