DISH Network 138410 用户手册

Press the DISH button on your remote control to use 

. 

Press the FORMAT/STAR button to toggle through the available 

display modes (Normal, Zoom) on widescreen displays.

Press the RECOVER button if you accidentally change the 

channel or video input on your TV and cannot get the picture 

back from your satellite receiver. When you press the 

RECOVER button as described below, the remote control sends commands 

to your TV to change channels or video inputs to try to get you back to 

watching satellite programming. This procedure works only if you have 

accidentally changed the TV channel or video input. It does not recover lost 

satellite signal (See Chapter 4 - Reference for troubleshooting information). 

RECOVER only works if the remote control has been set up to control the 

TV and/or VCR, if connected.

: You may need to press the RECOVER button up to 30 times to 

recover your satellite TV video.

1. Press and hold the RECOVER button until all four mode buttons light, 

and then let go of the button. The SAT mode button flashes twice and 
then all four mode buttons flash three times.

2. Press the RECOVER button. Wait for the TV mode button to flash 

once and then all four mode buttons to flash once.

3. If you see the

 screen, press the SELECT/OK button to 

close the screen. You have recovered your satellite video.

4. If you do not see the 

screen, repeat steps 2 and 3 until you 

have recovered your satellite video.

: If you have a DISH Network HD monitor, you may be able to use the 

SAT button instead of the RECOVER button to restore your TV back to 
watching satellite programming. See your DISH Network HD Monitor 
User’s Guide for details. Other buttons on your remote control that do not 
operate your satellite receiver are reserved for future use.