DISH Network Solo 351 用户指南

The

 connection provides the highest quality video 

available to your nearby TV (if your TV has this connection). 

Use an S-Video cable to make the connection. If you use this 

back panel output for video between your receiver and 

nearby TV, you must still connect the audio using the 

 and Phono (RCA) cables.

The 

 is used if you want the satellite 

receiver to connect the tuner of the nearby TV to an off-air 

antenna or cable TV system when the satellite receiver is 

turned off or when using the TV/VIDEO button on Remote 

Control 1. Use a coaxial cable to make this connection to an 

off-air antenna or cable TV system. The 

 connection is color coded black. Your nearby TV 

must be connected to the 

 output to use this 

feature.

The following connections provide TV2 menus and programming to the 

remote TVs.

The 

 connection provides good quality video 

and mono (non-stereo) audio for the remote TV(s). 

Use a coaxial cable to make this connection to your home 

cable system. Remote TVs connected to the home cable 

system can receive programming from this receiver output. 

The 

 connection is color coded yellow.

• If connecting directly to a TV tuner port, you must install the 

attenuator in the cable between the 

 port and the 

TV tuner.

• If connecting to your in-home cabling system to distribute the 

signal to a TV(s) in other rooms, in most cases you will not 

have to install the attenuator for most in-home cabling systems.

When connecting to the home distribution (

)

coaxial port, you must meet requirements covered under FCC

Compliance in the Appendix. To meet these requirements, an in-

line coaxial attenuator has been included with your receiver and

may need to be installed using the following guidance: