DISH Network Solo 351 用户指南

6. Make sure that the information on the 

 screen 

identifies your system correctly and shows all transponders for all 

satellites in your system. Your screen may look different from the 

example above depending on the dish antenna system you are using.

7. Select 

 to go to the 

 screen.

8. Select 

 to exit the Point Dish menu. An 

 screen will 

open asking if the mounting and positioning of your dish is complete 

with a 

 indication in the 

 screen. If the answer is yes, 

select Yes. 

 indication.

9. After you select Yes, the receiver will begin taking a software upgrade. 

You will see a Warning that 

. You will also see a status bar showing 

the progress of this upgrade.

10. Once the software upgrade is complete, you will see a message that your 

receiver’s memory is being upgraded.

11. Do not disturb the receiver while the receiver’s memory is being 

upgraded.

: If you are installing other DISH Pro or DISH Pro Plus receivers, 

be sure to run 

 on all of them, and allow them to take the 

necessary software upgrade.

12. When the memory upgrade is complete, you should be watching TV. 

Your dish antenna installation is now complete.