DISH Network Solo 351 用户指南

The 

 screen shows the 

 

.

Write down this address: 

3. Press and hold the SAT button on Remote Control 2 for about 

three seconds, until all of the mode buttons light up, and then 

let go of the SAT button.

4. Use the NUMBER PAD buttons to enter any number between 1 and 16, 

but not the one you wrote in step 2.
Write down the number you entered: 

5. Press the POUND (#) button. If you entered the address 

correctly, the SAT mode will flash three times. 

6. Press the RECORD button.
7. Make sure the 

 you see on the 

 screen is the same as the one you entered in step 

4. If it isn’t, the remote cannot control the receiver.

8. Press the SELECT button to close the 

 screen.

1. Press and hold the SAT mode button for three seconds, until 

all of the mode buttons light up, and then let go of the SAT 
button.

2. Press the POUND (#) button twice. The SAT mode button 

will flash the same number of times as the address number 

(three flashes means address 3).

Stray UHF signals can block signals from the remote control to the receiver. 

To prevent blocks, you can install a 10 dB attenuator (you can buy one from 

a consumer electronics parts store).

: This will help keep out stray UHF signals, but also cut down how far 

away you can use the remote control.

1. Take the UHF antenna off of the 

receiver’s back panel UHF Remote 
Antenna input.

2. Put a 10 dB attenuator onto the UHF 

Remote Antenna input.