DISH Network Solo 351 用户指南

: VCR setup is only available through TV1 menus.

To set up TV1 to control a VCR, use Remote Control 1 at the nearby TV and 

do the following:

1. Press the MENU button. 

2. Select the 

 option. 

3. Select the 

 option.

4. Select the 

 option.

5. Set the VCR code by doing one of the following:

•

Enter the 3-digit VCR code number, from the tables starting on page 

114, using the NUMBER PAD buttons. 

•

Highlight each digit of the VCR code, and then press the UP or 

DOWN ARROW button until you reach the correct number and 

then press SELECT.

6. Make sure the VCR is connected to one of the TV1 outputs and is set to 

display from the TV1 output to the nearby TV. Consult your VCR user’s 

guide.

7. Make sure the VCR is turned on. Insert a rewound tape on which you 

want to record. 

: The receiver only starts and stops the VCR recording, but does not 

turn ON the VCR, so you must do this yourself.

8. To test the new code, highlight the 

 option. The receiver displays a 

message warning you to make sure the VCR is turned ON.

9. Press the SELECT button to start the test. Your VCR records for a few 

seconds, stops, and then rewinds. The receiver displays a message 

saying that your VCR test is complete. Follow the instructions on the 

message. If your VCR did not do the test, enter another code from the 

table. Repeat step 8 and this step.

10. Once you have found the correct VCR code, select the 

 option to 

save the VCR code you entered and return to the 

 

menu.