DISH Network Solo 351 用户指南

: If you cannot find the signal, turn the dish back to the first azimuth angle. 

Then, loosen both elevation bolts just enough so you can tilt the dish. Tilt the 

dish elevation up by two degrees, and then tighten both bolts. Now, turn the dish 

back and forth again. If you still can’t find the signal, tilt the dish up again very 

slightly and turn the dish back and forth until you find the signal. Do not change 

the skew setting.

19. When the signal strength bar is green, turn the dish back and forth just a little, to 

where the signal strength bar shows the strongest signal. When you find the 

strongest signal, tighten both mast clamp bolts. Then loosen both elevation 

bolts, just enough so you can tilt the dish. Tilt the dish up and down just a little, 

to where the signal strength bar shows the strongest signal. When you find the 

strongest signal, tighten all bolts in the dish assembly so the dish cannot be 

moved.

20. You are now ready to verify reception from both satellites. Select the Check 

Switch option. When the Check Switch menu opens, select Retest. The 
receiver shows you a message that it is checking the system. When the 
procedure is finished, you will see an Installation Summary screen. This 
screen may look different than the one shown below. 
•

Satellite - 

in 

 and 

 in 

. 

•

 - 

 twice. This is OK and does not indicate a problem with 

the receiver. 

•

Device Type - 

 twice. This indicates that your receiver has confirmed 

the connection with your DISH Pro Twin LNBF is working. Press OK to 

exit this menu.”

•

 - 

.

21. If you do not see 

 under 

: 

•

Make sure the skew angle you wrote down on page 86 is exactly the same as 

the skew angle you set in step 5 on page 87. If it is not, reset the skew angle 

as described on page 87. After you reset the skew angle, go back page 89 

and start over from step 16.

•

If 

 is shown under 

, move the dish approximately 9° to the east 

and restart the procedure at step 12.

22. Look at the Point Dish menu. If you have good signal strength with 

119 is indicated by a green signal bar, select 110. If you have good signal 

strength on 110, go to step 23.