DISH Network MP1 产品宣传页

This should clear 

out any previously 

installed devices. 

Then, select Done. 

coaxial cable to 

the “Satellite In” 

port on the back 

of the receiver. 

DISH receivers will often not show when they are on signal if they have incorrect “Check Switch” 

information. For this reason, DISH users must clear current settings before pointing. To do this for most 

DISH receivers, follow these steps. The following instructions are based on a ViP

®

 211 receiver. 

If your receiver differs from the options shown, you may need to consult your receiver manual. The 

wording and display used in your receiver may differ slightly.

Select option 1,  

Point Dish.

from “Sat in” on 

back of receiver. 

Press Menu on 

your remote.  

Select option 6, 

System Setup.

Select option 1, 

Installation.

Select 

Check that there 

are no checkmarks 

by SuperDISH or 

Alternate. Select 

Test.

The receiver will 

go through a 

number of steps 

and then may 

warn that fewer 

satellites were 

detected. 

If so, select Save.  

It may ask you to 

confirm. If so, 

select Save again.