DISH Network 118523 用户手册

These instructions guide you through the installation of a satellite system which 
includes your receiver (included with this manual), and a DISH Pro DISH 500 
antenna system that can be identified by the DISH Pro logo shown below.

The first step in installing your dish antenna is to assemble the satellite dish, 
mount it, and point it in the general direction of a satellite. To do this, follow 
these instructions:

You need to find the satellites in the sky. To do this, you need to know the azimuth 
angle (the south, southeast, or southwest direction to the satellites) and the elevation 
angle (the angle up to the satellites) from your location, and the skew angle

.

 

1. Make sure that the batteries are fresh in both remote controls, and are installed 

properly. If needed, make sure that the remote is in SAT mode to control the 

satellite receiver. 

2. Make sure your satellite receiver is connected to your TV(s) and confirm that 

the remote controls are controlling the menus properly using the instructions in 

Chapter 2. Turn ON the television and receiver.

3. Display the 

menu on the nearby TV by pressing MENU and then 

6-1-1 using Remote Control 1 (unless your TV already displays this menu).

4. Enter your ZIP code in the 

 field.

5. Make sure that 

 is shown under 

.

6. The menu displays the azimuth, elevation, and skew angles. Write down these 

numbers in the blanks provided in the margin.