DISH Network 118523 用户手册

You can set your receiver to operate your TV1 using another UHF Pro remote 

control (sold separately) by completing the following instructions:

1. Perform the following using an existing remote control:

a. Open the 

 screen by pressing MENU-6-1-8 on the 

remote control.

b. Select 

 from the 

 screen.

c. Select

 to open the 

 screen.

d. Move the highlight to the address for the 

 as 

shown below. This is important - if you do not do this, your remote will 

change the receiver's 

 and cause your 

Remote Control 1 to control the 

 

side of your receiver.

2. Perform the following using the UHF Pro remote that you are going to use 

to control TV1:

a. Press and hold the SAT mode button about three seconds, until all the 

mode buttons light up, and then let go of the SAT button. The SAT 

mode button will blink.

b. Use the NUMBER PAD buttons to enter any number from 1 to 16, 

except for the number shown by the 

. The 

SAT mode button goes out after you enter each digit, and then lights up 

again.

Write down the number you entered: 

c. Press the POUND (#) button. If you entered the address correctly, the 

SAT mode button will flash three times.

d. Press the RECORD button.
e. Make sure the 

 screen shows that the 

 

 shows 

 

 and that this address 

matches the number you entered in step b.

If you set up your receiver to operate the 

 side using UHF Pro,

the two UHF Pro remotes for this receiver will interfere with

each other when operated at the same time. This may prevent

the remotes from operating the receiver momentarily.

Note: Highlight the 
Primary Remote 
Address.