DISH Network VIP612 用户手册

1

Press and hold the SAT mode button for three seconds, until all of the mode buttons light 
up, and then let go of the SAT button.

2

Press POUND (#) twice. The SAT mode button will flash the same number of times as the 
address number (for example, three flashes means address 3).

1

Make sure the remote has fresh batteries and is in SAT mode.

2

Press SYSTEM INFO on the receiver front panel to display the system information screen.

3

Press RECORD on the remote control:

The Remote Address in the system information screen changes to match the address 
preset in your remote control.

4

Press POWER on the remote control to turn on/off receiver.

Your receiver accepts both UHF and IR (Infrared) commands. The remote control only 
outputs UHF Pro signals but can be changed to transmit IR commands by switching the 
key at the bottom. This is also useful for programming an after-market universal learning 
remote control to operate your receiver. Note that when the remote control is in IR mode, 
you will need to use it from the same room to operate the receiver because IR signals do 
not travel through walls or over great distances.