Polycom 1725-31424-001 用户手册
Deployment Guide for the Polycom CX700 IP Phone
34
4.
Sign in to the Polycom CX700 phone using an account that is on the same
pool as the Device Update service.
pool as the Device Update service.
5.
Perform a Reboot— power cycle the Polycom CX700 phone to force it to
look for an update and leave it alone for five to ten minutes.
The phone should reset automatically and present the calibration screen
again.
You can monitor the IIS and ImageUpdate Audit log files for progress /
status.
look for an update and leave it alone for five to ten minutes.
The phone should reset automatically and present the calibration screen
again.
You can monitor the IIS and ImageUpdate Audit log files for progress /
status.
6.
Calibrate the phone, but do not sign in.
7.
Confirm the Polycom CX700 phone is running release 1.0.522.101 by
clicking About on the main menu and checking the Version information.
clicking About on the main menu and checking the Version information.
Click OK to return to the Sign in screen.
At this point Step 2 is confirmed and you can do one of two things:
• Add any remaining Polycom CX700 phones still running release
1.0.199.123 as “Test Devices”, power cycle them and within five to ten
minutes they should pick up the pending 1.0.522.101 (only Polycom
CX700 phones listed on the Test Devices tab can receive Pending Updates)
minutes they should pick up the pending 1.0.522.101 (only Polycom
CX700 phones listed on the Test Devices tab can receive Pending Updates)
OR
• If no other production Polycom CX700 phones are on a build higher than
1.0.522.101, you can use Device Updater to approve the pending updates
and finish flashing the software on the remaining phones running build
1.0.199.123.
1.0.199.123.
Once all Polycom CX700 phones are running release 1.0.522.101 and have been
recalibrated, go to the next section,
.
If the Polycom CX700 phone is not picking up downloads, be sure the client version
filter is set properly and that WMI has been configured with internal (BaseURL) and
external (ExternalBaseURL values.
filter is set properly and that WMI has been configured with internal (BaseURL) and
external (ExternalBaseURL values.
Also, make sure that if you have a build set to “Pending” that the corresponding
MAC address or serial number of the phone is listed on the Test Devices tab. You
can also refer to
MAC address or serial number of the phone is listed on the Test Devices tab. You
can also refer to
on page
for which logs to
check to begin the troubleshooting process.
There is a lag between when 1.0.522.101 is available and when the phone can
access it and the system logs the attempt. Be sure to allow for that (usually less
than 5 minutes.)
access it and the system logs the attempt. Be sure to allow for that (usually less
than 5 minutes.)