Peerless Industries KX-TDA30 用户手册
2.3 System Data Control
Feature Guide
297
2.3
System Data Control
2.3.1
PC Programming
Description
This PBX can be programmed and administered using a personal computer (PC). There are
two programming methods:
two programming methods:
1)
On-site Programming: System programming/diagnosis can be performed locally by
connecting a PC to the PBX directly.
connecting a PC to the PBX directly.
2)
Remote Programming: System programming/diagnosis and data upload can be
performed from a remote location.
performed from a remote location.
1.
On-site Programming:
Method
Description
Using the Serial
Interface (RS-232C)
port
Interface (RS-232C)
port
The PBX has a Serial Interface (RS-232C) port which can be
used for either system administration or SMDR (
used for either system administration or SMDR (
Using the USB port
The PC is connected to the USB port on the PBX, or a USB
port (USB Module) attached to a DPT.
port (USB Module) attached to a DPT.
Using the LAN
interface (KX-
TDA100/KX-TDA200
only)
interface (KX-
TDA100/KX-TDA200
only)
A CTI-LINK card must be installed.
Using a modem
through an SLT port*
(KX-TDA30/KX-
TDA100/KX-TDA200
only)
through an SLT port*
(KX-TDA30/KX-
TDA100/KX-TDA200
only)
An RMT card must be installed. Assign the floating extension
number of the analogue remote maintenance (
number of the analogue remote maintenance (
Floating Extension Number [811]), and dial this number from
the PC to connect to the PBX.
the PC to connect to the PBX.
Using an ISDN TA
interface (64 kbps)
through an ISDN
Extension Line*
interface (64 kbps)
through an ISDN
Extension Line*
Assign the floating extension number of the ISDN remote
maintenance (
maintenance (
[812]), and dial this number from the PC to connect to the
PBX. The RMT card is not required for this method.
This method is available only when a user-supplied ISDN TA
that supports CAPI is used.
PBX. The RMT card is not required for this method.
This method is available only when a user-supplied ISDN TA
that supports CAPI is used.
*: If remote access is disabled through system programming (
Programming [810]), then this on site programming cannot be done.