Aastra Telecom 6865i 用户手册

41-001523-00 REV00 – 04.2014

The following procedure describes the use of the Paging key on the IP phone. The procedure assumes you have already 
configured the Paging key using the Aastra Web UI.

Select from Key 1 through Key 16.

In the Type field, select Paging.

In the Value field, enter a multicast IP address and a port number for the Paging key. When you press this key, the 

phone initiates an outgoing multicast RTP session to the specified address using the specified port. (For example, 
239.0.1.15:10000).

Notes:
1. When you select Paging for the Type field, the Line field is disabled.
2. The Value field allows for one multicast address entry only.

To receive RTP steams for Group Paging, you must also configure the Paging Listen Addresses parameter at the 

path, Basic Settings > Preferences > Group Paging RTP Settings. For more information about setting this parameter, see 

Click Save Settings to save your changes

• The recipient of a Paging call can set a global Do Not Disturb (DND) to ignore any incoming pages.
•  For incoming Paging, the phone uses the Intercom configuration settings. The incoming Page is dependant on the 

Allow Barge In parameter setting and the Idling/On Call state.

On the IP phone, press the key you configured for Paging.
The phone opens a multicast RTP session and an outgoing OR incoming phone screen displays.

Press the Drop key to end the multicast RTP session and return to the idle screen.

If you enable global DND on the phone, the incoming multicast RTP session is dropped.